1. Unpack and unwrap the box. The box includes a filter, 2 filter cartridges, one Teflon tape and 2 washers. Inside the filter you will have a filter cartridge and inside the box an extra one.
2. Disconnect your showerhead from the shower arm & clean the thread with dry cloth to remove any debris. Now use the Teflon tape to wrap the thread of the shower arm to prevent any leaks
3. Place one silicon ring in the top side of the Purifit (the side which is to be connected to shower arm) and wrap the bottom side of Purifit with Teflon tape to prevent leaks.
4. Align the Purifit top end with the thread of the shower arm & rotate clockwise to tighten.
5. Flushing – Step away from the path of the water, turn on the water and let the water flow out for 3 minutes through the Purifit filter. This will flush out discolored water- this is carbon dust and is not harmful.
6. The silicon ring should be placed at the bottom end of the Purifit where the shower-head end goes. Align the bottom thread of Purifit with the Shower-head and rotate clockwise to tighten. Use a spanner to Tighten. If there are leaks, check/insert silicon rings and tighten again.The shower filter is now ready to use.
Read more : 7 benefits of a good shower filter